High beam bulb, replacing

Disconnect electrical connector at sealing cap.
Disengage spring clip -arrow- and remove sealing cap.

Fig 1: Removing Sealing Cap (Cabrio From 10.98)
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Disconnect harness connector -1- at bulb.

Fig 2: Disconnecting Harness Connector At Bulb (Cabrio From 10.98)
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Disengage spring clip -2- by pushing on locking lugs -3-.
Pull bulb -4- out of reflector.
Do not touch bulb during installation.
Insert new bulb so that lugs on laminated plate aligns with grooves in reflector.
Attach harness connector -1-.
Attach sealing cap and reconnect electrical connector.
Always check headlight setting after installing new bulb.