Check Control Module Version
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Seat adjustment, initiating On Board Diagnostic (OBD) .
- Switch on ignition.
- Press button -1- for "Rapid data transfer" mode.
- Switch on printer with Print button (warning lamp in button lights up).
- Press buttons -0- and -1-.
Indicated on display:
| Rapid data transfer Q 01-Check Control Module Version |
- Confirm entry with the -Q- button.
The control module identification will be shown on the V.A.G 1551 scan tool display, e.g.:
| 3B1959760XX Seat adjustment FS 0001 → |
Breakdown of the display:
- Part No. of control module, System designation (XX seat adjustment DS 0001)
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP button.
- Ignition must be switched on.
- Malfunctions have occurred at the start of or during the program (external interference?).
- Check diagnosis wires as well as voltage supply and Ground connection.
- Press buttons -0- and -6- to end the output.
Indicated on display:
| Rapid data transfer Q 06 End output |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Switch off ignition.
- Disconnect connector to V.A.G 1551 scan tool.