Evaluating display group number 003

WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Display zone	Designation	Display contents	Corrective action
1	Voltage supply	correct too low too high	Battery voltage min. 9 Volt Check alternator. Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations Check voltage regulator. Refer to Electrical wiring diagrams & Component locations Visual check of wiring
2	Passenger side seat occupant detection	not installed	no malfunction present
				Continued on next chart

Display zone

Designation

Display contents

Corrective action

Left Front Seatbelt Microswitch -F140-

not installed
belt: yes
belt: no
too high
too low
to Ground (GND)
to B+
not defined

If the switch is not installed or if "belt yes" is displayed with belt tongue inserted or "belt no" with the belt tongue not inserted, no malfunction is present

Visual check of wiring
Check harness connectors of the respective electrical circuit for proper and secure seating and observe the display at the same time If the display content changes to "correct", erase DTC memory

Right Front Seatbelt Microswitch -F141-

not installed
belt: yes
belt: no
too high
too low
to Ground (GND)
to B+
not defined

Replace faulty wires or harness connectors
Replace driver- or passenger-side belt buckle switch