Check DTC Memory
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Introducing On Board Diagnostic (OBD) for airbag .
- Switch on printer with Print button (warning lamp in button lights up).
- Press buttons -0- and -2- (the function "Check DTC memory" is entered with 02).
Indicated on display:
| Rapid data transfer Q 02 - Check DTC memory |
- Press "Print" button.
- Confirm entry with the -Q- button.
The number of stored malfunctions appears in the display.
| X DTCs recognized! |
The stored malfunctions are displayed and printed out one after the other.
- Enter DTC table at malfunction printed out and repair.
If "No DTC recognized" is displayed, the program will return to the initial position after pressing the → button.
| No DTC recognized! → |
Indicated on display:
| Rapid data transfer HELP Select function XX |
If something else is displayed:
Refer to Scan tool operating instructions
- End output (function 06). Refer to End output .
- Switch off ignition and separate diagnostic connections.
NOTE:
If a DTC is recognized:
- 1. Repair malfunction
- 2. Erase DTC memory (function 05).
- 3. Check DTC memory again (function 02).