Bumper cover, assembly overview
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2006 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.
1 - Bumper cover
- Material - PP/EPDM
- Removing. Refer to Bumper cover, removing and installing
2 - Bolt
- Qty. 7
- 6.6 Nm
3 - Guide piece
- To remove and install, pull out/slide in bumper cover parallel out of guide pieces (left and right sides).
4 - Wheelhousing liner
5 - Screw
- Qty. 8 for common models Golf/Jetta
- 1.5 Nm
- Qty. 10 for Jetta GLI Sport
6 - Speed nut
- Qty. 8 for common models Golf/Jetta
- Qty. 10 for Jetta GLI Sport
7 - Cover for headlight cleaning system
- Cover is part of headlight cleaning system
- For special models
8 - Spoiler
- For common models Golf/Jetta: clipped in on bumper cover
- For Jetta GLI Sport: delivered as by-pack
9 - Air guide grille, left
- Clipped in on bumper cover
10 - Air guide grille, center
- Clipped in on bumper cover
11 - Air guide grille, right
- Clipped in on bumper cover