Engine codes BBW, BEV
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Coolant hose connection diagram for engine codes BBW, BEV. Refer to Engine codes AVH, AZG, BBW, BEV
1 - To top of expansion tank
- Coolant hose connection diagram for engines BBW, BEV. Refer to Engine codes AVH, AZG, BBW, BEV
2 - O-ring
- Replace if damaged
3 - Quick release coupling
- Connection heater heat exchanger
4 - Connector
- 4-pin
- Wiring chamber 3 and wiring chamber 4 for Engine Coolant Temperature (ECT) sensor -G62-
- Gold plated contacts for ECT -G62-
5 - Engine Coolant Temperature (ECT) sensor -G62-
- For engine control module
- With Engine Coolant Temperature (ECT) Sensor -G2-
- Gold plated contacts for Engine Coolant Temperature (ECT) Sensor -G62-
- Release pressure in coolant system if necessary, before removing components
6 - Retaining clip
- Check seated securely
7 - Coolant pipe
8 - From ATF radiator (automatic transmission) or shape hose
- Coolant hose connection diagram for engines BBW, BEV. Refer to Engine codes AVH, AZG, BBW, BEV
9 - 10 Nm
10 - To bottom of expansion tank
- Coolant hose connection diagram for engine codes BBW, BEV. Refer to Engine codes AVH, AZG, BBW, BEV
11 - O-ring
- Always replace
12 - Union
13 - To top of radiator
14 - From bottom of radiator
15 - Oil cooler
- Ensure clearance to adjacent components
- Note. Refer to Lubrication system components, removing and installing
16 - 15 Nm
17 - Coolant thermostat
- Checking: Heat up thermostat in water
- Starts to open at approx. 86 ° C
- Opening stroke: min. 7 mm
- Removing and installing. Refer to Thermostat, removing and installing
18 - Toothed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing, installing and tensioning. Refer to Engine codes AEG, AVH, AZG, BEV
19 - Coolant pump
- Check for ease of movement
- If damaged or leaking replace complete
- Removing and installing. Refer to Coolant pump, removing and installing
20 - Rear toothed belt guard
21 - 20 Nm
22 - Washer
- Note part number
23 - Throttle valve control module
- Heated by coolant