Part II
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Knock sensor (KS) 1 -G61-
- Gold plated contacts
2 - Connector
- For Knock Sensor (KS) 1 -G61-
- Gold plated contacts
3 - 20 Nm
- Torque setting influences function of knock sensor
4 - Connector
- For Knock Sensor (KS) 2 -G66-
- Gold plated contacts
5 - Knock Sensor (KS) 2 -G66-
- Gold plated contacts
6 - Dipstick guide
7 - Dipstick
- Oil level must not exceed Max. mark!
- Markings. See Figure .
8 - Coolant pipe
- Depending on version
- Coolant hose connection diagram. Refer to Coolant hose connection diagram
9 - 25 Nm
10 - Bracket
- For ignition coil
11 - Bracket
- Depending on version
12 - 10 Nm
13 - Bracket
- Depending on version
14 - Bracket
- Depending on version
15 - Bracket
- Depending on version
16 - Oil filter bracket
- Disassembling and assembling. Refer to Oil filter housing, disassembling and assembling
17 - 15 Nm plus 1/4 turn (90 ° )
- Always replace
18 - O-ring
- Always replace
19 - Oil filter
- Loosen with strap wrench
- Tighten by hand
- Note instructions on filter when installing
20 - 25 Nm
21 - Oil cooler
- Coat contact surfaces to oil filter bracket outside the seal with AMV 188 100 02
- Ensure clearance to adjacent components
- See notes. Refer to Assembly overview
22 - O-ring
- Always replace
23 - Engine speed sender
24 - O-ring
- Replace if damaged
25 - 40 Nm
26 - Union
27 - 15 Nm
28 - Thermostat
- Checking: Heat up thermostat in water
- Starts to open at approx. 86 ° C
- Opening stroke min. 7 mm
- Removing and installing. Refer to Thermostat, removing and installing
29 - Hex socket head bolt, 45 Nm
30 - Compact bracket
- For V-belt tensioning roller, Generator, power steering pump and air conditioning compressor
Refer to A/C COMPRESSOR AND BRACKET
31 - Cylinder block
- Removing and installing sealing flange and flywheel/drive plate. Refer to Sealing flanges and flywheel/drive plate, removing and installing
- Removing and installing crankshaft. Refer to Crankshaft, removing and installing
- Disassembling and assembling piston and connecting rod. Refer to Assembly overview