Turbocharger cooling system components, removing and installing (engine codes 1Z, AHU)
WARNING: This page is about a different car, the 1996 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- All hose connections secured by clips.
- Charge air system must be free of leaks.
The following list pertains to Fig 1 .
- Rubber mounting
- Spacer
- 10 Nm (7 ft lb)
- 10 Nm (7 ft lb)
- Connecting pipe
- Between charge air cooler and turbocharger
- O-ring
- Replace if damaged
- Retaining clip
- Intake Air Temperature (IAT) sensor -G72-
- Connecting pipe
- Between charge air cooler and intake manifold
- Charge air cooler
- Air ducting
- Retainers