Crash sensor for side airbag, driver's and front passenger side, removing and installing: Notes
NOTE:
The following list refers to Fig 1
.
- - Crash sensor for side airbag, driver's and passenger side
- - Connector
- - Bolt
- 10 N.m (89 ft. lb)
- - Carpet
- - Cover
- Disconnect battery Ground (GND) strap.
- Remove driver's or front passenger seat.
- Release carpet - 4 - and insulation mat in area of sensor.
- Pry off cover - 5 -.
- Disconnect connector - 2 - and remove screws - 3 -.