Break down of display content for display group number 013
WARNING: This page is about a different variant/trim than selected.
| Display group 013 -Central control module- | ||||||
| Read measured value block 13 | → | ← Indicated on display | ||||
| xxx | xxx | xxx | xxx | |||
| 1 | 2 | 3 | 4 | ← Display zones | Specification | Evaluation |
| Empty1) | ||||||
| Instrument illumination (in 16 steps, 0...100%) | mv (in 16 steps) | Refer to Evaluating display group number 013 | ||||
| Rear, first detent 2) | open, closed, not installed |
|||||
| Rear lid button and rear lid handle 3, 4) | not oper. TG hndl op implausible |
|||||
1) Empty means in this case: Display zone is blank
2) Lock rotary latch must be engaged in first detent
3) Rear lid remote opening button and rear lid handle
4) Fault recorded if operated for longer than 10 seconds