CD Changer position (V/H) switches, setting

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying CD Changer Position (V/H) Switches

GW00004371

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Check and confirm CD Changer position settings via V/H switch (or switches) -arrow- where applicable.
Loosen V/H switch retaining screw, slide switch towards the appropriate position according to CD Changer's installation position ("V" = vertical, or "H" = horizontal) and tighten.

Tightening torque: 3 Nm (27 in lb)

NOTE:

CD playback will skip if switches are not set correctly.
Always check/set switches prior to CD installation.
Switches must move completely to their end positions.
Before sliding CD Changer into CD Changer bracket ensure that the CD Changer cable and connector route to the front side of the CD Changer.