Amplifier - Jetta, removing and installing

WARNING: This page is about a different variant/trim than selected.

Removing

CAUTION:

Before beginning repairs on the electrical system:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Remove parcel shelf trim. Refer to 70 - INTERIOR TRIM .

Fig 1: Identifying Amplifier Screws - Jetta

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen (do not remove) screws -1- (tightening torque: 5.5 Nm).
Release amplifier assembly from mounting position by sliding towards the perforations in the rear shelf sheet metal - arrow-.

Fig 2: Identifying Amplifier Electrical Connections

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connections at amplifier by depressing both securing lugs on each plug.

CAUTION:

Always disconnect the green plug last in order to better support the weight of the amplifier assembly when it hangs on the wiring harnesses.

Fig 3: Identifying Amplifier Mounting Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove amplifier mounting screws as illustrated in detail.
Slide amplifier from mounting frame in direction of -arrow-.

Installing

Install in reverse order of removal.
Ensure radio is coded accordingly for "Monsoon" system using On Board Diagnostic program function 07, "Code Control Module": Radio system "Premium V". Refer to Code Control Module (radio) (function 07) . Radio system "Premium VI". Refer to Code Control Module (radio) (function 07) .

NOTE: Radio sound system coding must be checked/performed in order to account for presence of CD Changer (if installed), Monsoon system (where applicable) and interior sound field differences between models.