Diagnostic Trouble Code (DTC) memory, erasing (function 05)
WARNING: This page is about a different variant/trim than selected.
NOTE:
After erasing the DTC memory its contents will automatically be indicated. If the DTC memory cannot be erased, again check DTC memory and repair malfunctions.
Requirements
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC) memory, checking (function 02) .
- All malfunctions repaired.
After Diagnostic Trouble Code (DTC) memory has been successfully checked:
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press keys 0 and 5. (05 selects the "Erase DTC memory" function.)
| Rapid data transfer Q 05 Erase DTC memory |
Indicated on display:
- Confirm entry with key Q.
| Rapid data transfer → DTC memory is erased! |
Indicated on display:
The DTC memory is now erased.
- Press → key.
| Rapid data transfer HELP Select function XX |
Indicated on display:
NOTE:
- If this appears in the display, the test sequence is faulty.
- If this appears in the display, the test sequence is faulty.
- Adhere exactly to test sequence: First check DTC memory, if necessary repair malfunctions, then erase.