Totally discharged batteries, charging
WARNING: This page is about a different variant/trim than selected.
WARNING:
Danger of injury! Prior to handling or servicing batteries, read, understand and observe the Warnings and Safety Measures. Refer To Warnings and Safety Measures
!
CAUTION:
Batteries that have a colorless or light yellow "Magic Eye" charge indicator must not be tested or charged. Jump starting is not permitted!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
Note:
- Batteries that have not been used for long periods of time begin to self discharge (e.g. vehicles in storage). Under these conditions, the battery begins to sulfate and the surface area of the battery plates hardens. A battery is considered to be discharged when the no-load voltage is less than or equal to 11.6 V. No load voltage, checking. Refer To Battery no load voltage - vehicles in storage, checking
- On discharged batteries, the electrolyte (sulfuric acid/water mixture) is almost all water. When these batteries are exposed to freezing temperatures, permanent damage to the battery plates (and housing) results.
- The sulfating process may be reversed if a totally discharged battery is recharged immediately.
- If a totally discharged battery is charged quickly ( "quick charged" or "boost charged" ), only a surface charge is accepted (if at all). The battery may even test OK immediately after charging. However, in this case the sulfating process continues inside the battery. Once a battery begins to sulfate, its ability to further accept a routine charge (from the Generator) and provide adequate load and reserve performance will diminish until the battery malfunctions.
- Totally discharged batteries must only be slow charged and retested.
- Apply a maximum charge current that is no more than 10% of battery capacity, e.g.: for a 60Ah battery, max. charge current = 6 amps.
- Charge a totally discharged battery for a minimum of 24 hours.
- Check no load voltage. Refer To Battery no load voltage - vehicles in storage, checking .
- Charge the battery.
Charging battery using Midtronics Inc-940 Batt. Charg. Stn. INC-940. Refer To Battery, charging .
CAUTION:
- Discharged batteries freeze prematurely.
- Frozen batteries or batteries that have been frozen and subsequently thawed must no longer be used.
- Never "quick charge" a totally discharged battery. Effective charging will not take place, despite what appears to be a sufficient voltage applied. Batteries loaded in this manner may be incorrectly evaluated as OK and battery damage may result.