Battery charger, connecting

WARNING: This page is about a different variant/trim than selected.

CAUTION: Danger of explosion!

Batteries produce explosive gasses while being charged.
Keep open flames and sparks away and DO NOT smoke near batteries.
The battery charger MUST be turned off when connecting or disconnecting the cables at the battery.
Battery cell caps must NOT be removed while charging.
"Boosting" a sulfated battery a high charging rate can cause an explosion.
Ensure that battery is charged in a well ventilated area.
Precision tools must not be kept in the same room where batteries are being charged. Tools may corrode due to chemical reaction.

Special tools, testers and auxiliary items required

NOTE:

Before charging, battery must have a minimum temperature of 10 degrees Celsius (50 degrees Fahrenheit).
It is not necessary to remove battery from vehicle or disconnect battery terminals.
Charging voltage must not exceed 14.4V.
Always follow the battery charger operating instructions.
After charging, confirm battery no load voltage and electrolyte specific gravity before reuse in vehicle.

CAUTION: Before beginning repairs on electrical system

CAUTION: If battery begins gassing (boiling) violently when charging, REDUCE charging rate immediately.

Connect battery charger to battery, positive to positive ( + ), negative to negative ( - ).
Switch on battery charger.
Adjust charging rate according to battery capacity (refer to charger instructions).