Ignition/starter switch, removing and installing
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified in this article . Refer to Battery with fastened fuse holder, disconnecting and reconnecting .
Removing
- Disconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting .
- Remove steering column switches. Refer to Steering column switches, removing and installing .
- Disconnect electrical connector from ignition/starter switch.
- Remove locking paint on securing screws -A-.
- Loosen two securing screws -A- slightly and pull ignition/starter switch out from steering lock housing in direction of -arrow-.
Installing
Install in reverse order of removal, noting the following:
- Push ignition/starter switch into steering lock housing.
NOTE:
When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on".
- Tighten securing screws and seal with locking paint.
- Connect electrical connector to ignition/starter switch.
- Reinstall steering column switches and steering wheel.