Windshield wiper arms, removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Fig 1: Identifying Wiper Arm Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Wiper arm nuts -1- must be only be torqued after the wiper blade park position is adjusted properly.

Switch ignition on and briefly turn wipers on and off (wipers must come to a complete stop)
Switch off ignition and remove ignition key.
Mount wiper arms to wiper shaft and loosely install nuts -1- (do not tighten).
Adjust wiper blade park position. Refer to Wiper blade park position, adjusting .