Windshield washer jets, checking and adjusting
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Washer jets must not be cleaned opposite to the spray direction, e.g.: blown through from front.
Through m.y. 1999
Washer jets are preset but small height adjustments can be made.
If both spray fields are not at the same height (as illustrated), correct as follows:
- Slightly turn eccentric on spray jet in direction of arrow with a screwdriver.
From m.y. 2000
- New design washer jets are installed from m.y. 2000.
Washer jets are preset but small height adjustments can be made.
Both spray fields are defined with points A & B.
Distance between points A & B and upper windshield are indicated in a straight line as follows.
| Point | Distance |
| A | 480 mm (18.8 in.) |
| B | 400 mm (15.7 in.) |
- Move spray jet in direction of arrow with finger.