Instrument cluster, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
- Insert instrument cluster into opening and reconnect electrical connections.
- Secure wiring harness for blue 32-pin multi-pin connection to retainer -arrow- on rear of instrument cluster (where applicable).
- Remaining installation in reverse order of removal.
- Perform functional check of instrument cluster.
If replacing a malfunctioning instrument cluster, and a function check shows no further malfunctions, proceed as follows:
Through m.y. 1999
- Code instrument cluster
Refer to 01 ON BOARD DIAGNOSTIC (OBD) .
- Adapt odometer reading.
Refer to 01 ON BOARD DIAGNOSTIC (OBD) .
From m.y. 2000
- Perform necessary instrument cluster adaptations and coding, including coding the Data Bus On Board Diagnostic Interface -J533- as per OBD program
Refer to VAS 5051/5052 Vehicle Diagnostic Testing and Information System in mode "Guided Fault Finding" VAS 5051, connecting .