VAS 5051/5052, connecting
WARNING: This page is about a different variant/trim than selected.
- Engage parking brake.
- Automatic transmission: Selector lever in "N" or "P" position.
- Manual transmission: Selector lever in "Neutral" position.
- With ignition switched off, connect VAS 5051/5052 with adapter cable to Data Link Connector (DLC) located under the instrument panel, left.
- Switch on ignition
- Select mode "Guided Fault Finding"
- Enter appropriate model, equipment and model year information and press ">" to confirm.
After all Control Modules have been registered and DTC memories checked,
- Select "Go to"
- Select "Function / Component Selection"
- Select "Body (Refer to BODY EXTERIOR , BODY INTERIOR and BODY ON BOARD DIAGNOSTIC (OBD) "
- Select "Electrical System (Refer to 27 Battery, Starter, Generator, Cruise control , 90 Instruments to 97 Wiring )
- Select "01-Systems capable of self-diagnosis"
- Select "Instrument panel" or "dash panel insert" where indicated
- Select "Functions"
- Select "Replacing instrument cluster with immobilizer 3.gen" or "Instrument cluster, replacing" as applicable.
- Forward with " => " button
- Follow/perform selected OBD program steps as prompted by tester.