Cruise control system - 1.8L Turbo, 2.0L (codes AVH & AZG) and 2.8L VR6, activating
WARNING: This page is about a different variant/trim than selected.
If a Motronic Engine Control Module (ECM) has been replaced, it may be necessary to activate the cruise control function in the new ECM. Activate/deactivate system using the following procedure:
- Connect VAG 1551/1552 Scan Tool. Refer to VAG 1551 Scan Tool (ST), connecting and selecting functions .
- Switch on ignition
- Press buttons -0- and -1- to select Address word 01: "Engine electronics".
Display (example only)
| 021906018B Motronic ME7.1 G V06 → Coding 00000 WSC XXXXX |
- Press → button.
Display will appear as shown
| Rapid data transfer HELP Select function XX |
- Press buttons -1- and -1- to select function 11 "Login procedure"
Display will appear as shown
| Rapid data transfer Q 11 - Login procedure |
- Press -Q- button to enter input.
Display will appear as shown
| Login procedure Input Code Number XXXXX |
- To activate or deactivate cruise control system, use scan tool key pad to enter appropriate value from table below:
| Engine (code) - m.y. | Activate | Deactivate |
| 1.8L & 2.8L - through m.y. 1999 | 00003 | 00004 |
| 2.0L, 1.8L & 2.8L - from m.y. 2000 through m.y.2001 | 11463 | 16167 |
- Press -Q- button to enter input.
- End output (function 06) and perform test drive to confirm cruise control functions.