Evaluating display group 050

WARNING: This page is about a different variant/trim than selected.

Display field	Description		Display	Corrective actions
1	Distance travelled		Distance travelled in km	Visually check wire routing Check harness connectors of the appropriate electrical circuit for proper and secure seating and simultaneously observe display If the display content does not change during operation, repair malfunction or replace the relevant component Erase DTC memory Perform functional check Check DTC memory again
	2	Engine speed (RPM)		Engine speed in rpm
	3	Engine Oil temperature1)		Engine oil temperature in ° C
	4	Engine Coolant Temperature (ECT)		Engine coolant temperature in ° C

1) Where applicable

NOTE:

Display fields in display groups 125 and 126 provides the CAN-Bus function status codes of various control modules connected to the "Powertrain" CAN-Bus network.
If a vehicle is not equipped with control module(s) listed in the following display groups, the applicable display field remains blank. Check correct coding of CAN-Bus On Board Diagnostic (OBD) interface -J533-. Refer to Gateway, coding (function 07) .
Display field content differs between VDO and MMO instrument clusters!