Diagnostic Trouble Code (DTC) memory, erasing (function 05)
WARNING: This page is about a different variant/trim than selected.
NOTE:
After DTC memory is erased, its contents are automatically output. If DTC memory cannot be erased, check DTC memory again and repair malfunction.
Prerequisites
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC) memory, checking (function 02) .
- All malfunctions repaired.
After successful DTC memory check:
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons -0- and -5- to select "Erase DTC memory" function 05.
Indicated on display:
| Rapid data transfer Q 05 Erase DTC memory |
- Press -Q- button to confirm input.
Indicated on display:
| Rapid data transfer → DTC memory is erased! |
DTC memory is erased.
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If this appears in the display, the test sequence is faulty.
- If this appears in the display, the test sequence is faulty.
- Follow test sequence exactly: first check DTC memory, repair malfunction(s) if necessary, then erase.
NOTE:
After erasing the DTC memory its contents will automatically be indicated. If the DTC memory cannot be erased, again check DTC memory and repair malfunctions.