LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 1999 >> Golf Wolfsburg Edition, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Electrical Equipment On Board Diagnostic (OBD) (A4 Platform)) >> 01 On Board Diagnostic (OBD) >> Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m.y. 2001, On Board Diagnostic (OBD) >> Read Measuring Value Block (function 08) >> Display groups, interpreting >> Evaluating display group 125

Evaluating display group 125

WARNING: This page is about a different variant/trim than selected.
Display field  Description  Display  Corrective action 
1 Engine Control Module (ECM) Engine 1 = OK,
Data reception via CAN Bus OK
Engine 0 = not OK,
Data reception via CAN Bus not OK
  • Visually check CAN Bus wire routing
  • Check harness connectors of the appropriate electrical circuit for proper and secure seating and simultaneously observe display
  • If the display content does not change during operation, repair malfunction
  • Erase DTC memory
  • Perform functional check
  • Check DTC memory again
2 Transmission Control Module (TCM) Transm. 1 = OK,
Data reception via CAN Bus OK
Transm. 0 = not OK,
Data reception via CAN Bus not OK		  
3 ABS-control module ABS 1 = OK,
Data reception via CAN Bus is OK
ABS 0 = not OK,
Data reception via CAN Bus not OK		  
4 Airbag-control module Airbag 1 = OK,
Data reception via CAN Bus is OK
Airbag 0 = not OK,
Data reception via CAN Bus not OK		  
scientia non olet · About LEMON Manuals