Front seats, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in the reverse order of removal.
- Switch on ignition.
CAUTION:
Make sure that no persons are in the vehicle.
- Connect batteries → 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
NOTE:
- If the Airbag Malfunction Indicator Lamp (MIL) -K75- signals a malfunction, DTC memory must be erased and then checked again using the VAG 5051 tester.
- In place of "On Board Diagnostic (OBD)" , only the Vehicle Diagnosis, Testing and Information System VAS 5051 in the "Guided Fault Finding" function must be used for troubleshooting.