Lower A-pillar trim, removing and installing: Removing
WARNING: This page is about a different variant/trim than selected.
- Remove front hood release lever → 55 HOOD, LIDS
- Loosen cover - 1 - with clips - 2 - from instrument panel - 3 -.
- Pull out cover - 1 - - arrow -.
- Remove four bolts - 2 -.
- Carefully pull glove compartment - 1 - slightly from instrument panel - 3 - - arrow -.
- Unclip trim - 1 - at top from A-pillar - 2 - and loosen from sill panel trim - 3 - at bottom.
NOTE:
- Trim - 1 - is secured with two metal clips - 4 -.