Angle bracket, installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Angle Bracket & Securing Cap

GW00003662

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Guide angle bracket - 1 - into roof hole and press into roof hole until securing cap - 2 - engages. All catches must engage.

NOTE:

Securing cap must not be turned on angle bracket before it locks in.

Fig 2: Identifying Angle Bracket, Securing Cap & Bolts

GW00003663

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press angle bracket - 1 - on inner side panel, secure with bolts - 3 - (20 Nm).

NOTE:

At center angle bracket, bolt points are situated next to one another.

Unscrew securing cap - 2 - from outside, use a tool if necessary.