Stoplight, removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Primer dries very fast and permanently stains painted surfaces.
If any visible part of the vehicle gets stained with primer, clean it thoroughly before primer dries.

Fig 1: Identifying Stoplight Support & Support Base

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Slide stoplight wiring harness through hole in stoplight support - 1 -
Route wiring harness through drill hole in spoiler and pull wiring harness from support base - 2 -.

NOTE:

Make sure that stoplight is pulled tight to support, and if needed adjust slack in wiring harness.

Fig 2: Identifying Stoplight Attach To Spoiler By Screwing Stoplight Into Spoiler Support Base

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Attach stoplight to spoiler by screwing stoplight - 1 - into spoiler support base.

Fig 3: Identifying Wiring Harness Inserted Into Grommet

Courtesy of VOLKSWAGEN UNITED STATES, INC.