Preparing window flange for glazing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cutting Back Remaining Material Using Scraper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Cut back remaining material using Scraper V.A.G 1561/8 , do not remove all residue under any circumstance.

NOTE:

Residual material acts as a base for new adhesive sealing material. Keep adhesive surface free of dirt and grease.

CAUTION: Activator must not come into contact with paint - otherwise paint will be damaged.

Exception: If bonding is not performed immediately after cutting back, remaining material must be activated using Activator D 181 801 A1 .

NOTE:

If body flange is being worked on or is partially replaced, it must be cleaned and primed again after painting corresponding area.