Preparing undamaged window for glazing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cutting Back Remaining Adhesive Sealant

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

When re-using an undamaged window, cut back remaining adhesive sealant to 1 - 2 mm shortly before re-adhering, do not damage primer and ceramic coating.
Residual material acts as a base for new adhesive sealing material.

CAUTION: Do not prime or use a cleaning solution on adhesive surface. Keep adhesive surface free of dirt and grease.

Exception: If bonding is not performed immediately after cutting back, remaining material must be activated using Activator D 181 801 A1 .