Slotted guide rail, removing
WARNING: This page is about a different variant/trim than selected.
- Removing glass panel for sunroof. Refer to Glass panel for sunroof, removing .
- Removing installation unit. Refer to Installation unit, removing and installing .
- Removing drive motor for sunroof. Refer to Drive motor for sunroof, removing .
- Unclip end piece - 1 - from guide rail - 2 - - arrows - and then remove.
NOTE:
- When installing end piece - 1 - , seal against guide rail with Butyl adhesive sealing cord AKL 450 005 05 .
- Using a screw driver, unhook water channel - 1 - carefully on both sides at bearing on guide catch - 2 - and remove.
- Slide rear guide - 1 - in direction of - arrow - in guide rail - 4 - until lock mechanism of guide catch - 3 - is released.
- Remove rear guide - 1 - , guide catch - 3 - and slotted guide rail - 2 - together out of guide rail - 4 -.
NOTE:
- Always replace guides and cable as a set.