Rear lid lock, removing and installing

1 - Lock cylinder housing 

• Removing and installing. Refer to Lock cylinder housing, removing and installing 

2 - Handle 

• Removing. Refer to 70 - INTERIOR TRIM

• Remove bolt , disconnect connector for switch and remove handle from lid.

3 - Tailgate/trunk lid release switch E165  

4 - Bolt 

• 7 Nm

5 - Carrier plate 

6 - Operating rod 

7 - Nut 

• 7 Nm

8 - Tailgate/trunk lid release motor V139  

• Removing. Refer to 70 - INTERIOR TRIM

• Disconnect connector from motor.
• Unclip operating rod from lock cylinder housing.
• Unclip operating rod from motor for rear lid release.
• Remove hex nuts and remove carrier plate.

• Remove motor for rear lid release from carrier plate.

9 - Operating rod 

10 - Bolt 

• 22 Nm

11 - Lock 

• Removing

• Remove lid trim. Refer to 70 - INTERIOR TRIM
• Disconnect connector from lock.

12 - Rear lid 

13 - Actuator lever with linkage clip