Micro-switch, removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Micro-Switch, Retaining Profile & Wires

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure wires - 1 - and - 2 - in retaining profile - arrow - of micro-switch - 3 -.

Fig 2: Identifying Micro-Switch, Catches & Lock Cylinder Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Identifying Securing Tabs On Lock Cylinder Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Make sure that micro-switch is positioned with securing tabs - arrows - on lock cylinder housing - 1 -.
Before locking micro-switch, if must be checked that wires are lying correctly in retaining profile of micro-switch and lock cylinder. If this is not case and micro-switch is locked, wires/micro-switch may be damaged.

Fig 4: Identifying Release Catches At Micro-Switch & Lock Cylinder Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lock micro-switch - 1 - with lock cylinder housing - 2 -. Make sure that catch - arrow - is engage correctly.
Install lock cylinder housing. Refer to Lock cylinder housing, removing and installing .