Lock carrier with attachments, removing and installing
WARNING: This page is about a different variant/trim than selected.
1 - Lock carrier with attachments
Removing
- Unhook Bowden cable at lock and disconnect electrical connectors.
- Disconnect connectors at headlight housings.
- Removing front bumper and bumper carrier. Refer to Bumper cover, assembly overview .
- Disconnect hose for headlight cleaning system at T-piece.
- Unbolt radiator and condenser from lock carrier.
- Secure radiator and condenser in engine compartment. Refer to 87 - AIR CONDITIONING .
NOTE:
- Do not unhook condenser at lines.
- Condenser lines must not be kinked.
Installing
- Align lock carrier at long members and between fenders.
Gaps dimensions. Body panel gaps; Body, front
- Adjust headlights.
2 - Bolt
- Qty. 2
- 8 Nm
3 - Bowden cable
4 - Hole in side panel
5 - Radiator and condenser
6 - Bolt
- Qty. 4
- 8 Nm
7 - Bumper carrier
8 - Bolt
- Qty. 4
- 20 Nm
9 - Guide rods 3411