Tie rod, removal and installation: Removing
WARNING: This page is about a different variant/trim than selected.
The tie rods can only be removed/installed with the steering gear removed.
Power steering gear, removing and installing → Power steering gear, removing and installing
- Seal line connections on power steering gear if not already done.
- Clean outside of power steering gear in the area of the boot.
- Open clamp and slide boot back.
- Tighten power steering gear on transmission support T10108 and unscrew tie rod from connecting rod.
NOTE:
- Use only hole "5" and the allocated upper hole from transmission support to tighten power steering gear.