Tie rod, removal and installation: Installing
WARNING: This page is about a different variant/trim than selected.
Further installation is in the reverse sequence to removal.
Torque specification
Tie rod to power steering gear 75 Nm
Installing boot
- Inspect boot for wear (cuts, tears) and check that sealing surfaces for boot are clean.
- Installing boot. Turn the tie rod so that the tie rod ball joint shank is in the installation position.
NOTE:
- Use only genuine clamp.
- Tighten clamp with Hose Clamp Pliers V.A.G 1275.
- Install power steering gear
Power steering gear, removing and installing → Power steering gear, removing and installing