Power steering gear, removing and installing: Notes

Fig 1: Identifying Special Tools - Power Steering Gear, Removing And Installing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm dia. 3094
• Torque Wrench 5-50 Nm V.A.G 1331
• Torque Wrench 40-200 Nm V.A.G 1332
• Engine and transmission jack V.A.G 1383 A with universal transmission mount V.A.G 1359/2

The following special tools are necessary for R32 

Special tools, testers and auxiliary items required

Fig 2: Lower Control Arm Assm. Device 3293

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Lower Control Arm Assm. Device 3293

Fig 3: Installing tool 40-503

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Installing tool 40 - 503
• Ball Joint Puller T10239

Instructions when working on the power steering gear 

• Absolute cleanliness is required when working on the power steering system.
• Thoroughly clean connections and immediate vicinity before loosening.
• Place parts on a clean surface and cover if not re-installing immediately.
• Do not use fluffy cloths.

• Remove replacement parts from packaging immediately prior to installation.
• Only use genuine packed parts.