Toe on rear axle (vehicles front wheel drive), adjusting

If a value lies outside the tolerances, check trim height and balance if necessary.

The total toe for the rear axle is not adjustable.

Only by moving the mounting bracket is it possible to adjust the individual toe evenly.

If the measured values are outside the permitted tolerances the axle beam must be checked for damage and replaced if necessary.

• Loosen all bolts on mounting brackets - 1  -.

Fig 1: Mounting Bracket And Rear Axle Beam

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Slide mounting bracket - 1  - laterally.

2 - Rear axle beam

• Tighten bolts to 75 Nm.
• Always use new bolts!