Bonded rubber mountings for final drive, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation position of bonded rubber mounting
Arrow on bonded rubber mounting - 1 - must point up or down.
- Position special tool.
- Pull out bonded rubber mounting by turning spindle.
1 - Bonded rubber bushing
Installation of subframe and spring is performed in reverse order
| Torque specifications: | |
| Mounting bracket to body | 75 Nm |
| Stabilizer bar to subframe | 20 Nm |
| Driveshaft to final drive | 60 Nm |
| Mounting bracket to body | 75 Nm |
| Shock absorber to trailing arm | 110 Nm |
| Cross member for final drive to subframe | 60 Nm |
| Support for final drive to subframe | 60 Nm |