Bonded rubber mounting for subframe, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
The bonded rubber mounting is supplied as a spare part in a sealed plastic bag.
Do not use a bonded rubber mounting which has been stored unsealed!
- Assemble special tool with bonded rubber mounting.
1 - Screw T10030/3
2 - Washer with chamfer
3 - Press piece 10030/4
- Shoulder - arrow - faces toward bonded rubber mounting
4 - Bonded rubber bushing
- Coat bonded rubber mounting with, for example, soft soap.
- Install bonded rubber bushing and special tools on subframe.
- Pull out bonded rubber mounting by turning spindle.
1 - Washer
2 - Installation position of bonded rubber mounting in subframe
Spindle must be inserted from below to remove and pull in the subframe front bonded rubber mounting.
Further installation of the subframe is performed in reverse order