Threads in longitudinal member, servicing
WARNING: This page is about a different variant/trim than selected.
It is possible to service the threads of the weld nuts in the longitudinal member depending on certain conditions.
- Servicing work may only be carried out once per thread.
- If servicing is necessary after this, the nuts must be replaced.
- Observe the operating instructions of the VAS repair kit.
CAUTION:
When drilling, it is essential that eye protection be worn!
- Have the thread repair checked by the responsible foreman or next person in charge.
- Correct any damage to the underbody sealant layer. General information; Body collision repair; Measures for corrosion protection
- Only use the VAS repair kit listed in the table for maintenance
VAS thread repair kit
| Thread | VAS number |
| M10 | 6024 |
| M12x1.5 | 6058 |
| M14x1.5 | 6027 |