Bonded rubber bushings for subframe, replacing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Subframe And Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - 1 - for subframe.
By loosening bolts - 2 - lower subframe as far as possible, until bonded rubber bushings are accessible.

Fig 2: Pulling Subframe Bonded Rubber Bushings Upper Half Out

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fig 3: Pressing Subframe Upward Using Base Block VW 441

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert thrust plate VW 447 H from above.
Press subframe upward using Base Block VW 441 and engine/transmission jack V.A.G 1383 A until lower half of bushing falls out.