Test step overview
WARNING: This page is about a different variant/trim than selected.
| Component to be tested | |||
| Voltage supply for ABS hydraulic pump -V64- to ABS control module (w/EDL) -J104- |
|
||
| Voltage supply for valves in ABS hydraulic unit -N55- to ABS control module (w/EDL) -J104- |
|
||
| Voltage supply (ignition/starter switch) to ABS control module (w/EDL) -J104- |
|
||
| Function of brake light switch -F- |
|
||
| Resistance of right front ABS wheel speed sensor -G45- |
|
||
| Resistance of left front ABS wheel speed sensor -G47- |
|
||
| Resistance of right rear ABS wheel speed sensor -G44- |
|
||
| Resistance of left rear ABS wheel speed sensor -G46- |
|
||
| Voltage signal of right front ABS wheel speed sensor -G45- |
|
||
| Voltage signal of left front ABS wheel speed sensor -G47- |
|
||
| Voltage signal of right rear ABS wheel speed sensor -G44- |
|
| Component to be tested | |||
| Voltage signal of left rear ABS wheel speed sensor -G46- |
|
||
| Warning lamp function for ABS warning light -K47- |
|
||
| Warning lamp function for warning light for brake system -K118- |
|
||
| Warning lamp function for ESP control lamp -K155- |
|
||
| Function of ASR/ESP button -E256- |
|
||
| Activation of steering angle sensor -G85- |
|
||
| Activation of sensor for transverse acceleration -G200- Activation of sender for rotation rate -G202- |
|
||
| Activation of sender 1 for brake booster -G201- |
|
||
| Check of data bus wiring |
|
||
| Voltage supply for V.A.G 1551, connector T16 |
|
||
| Resistance of K wire for self-diagnosis, connector T16 |
|
||
| Coding bridge |
|