Test step overview

WARNING: This page is about a different variant/trim than selected.

To test component
Voltage supply for ABS hydraulic pump -V64- to ABS control module (w/EDL) -J104-		Perform test step 1
Voltage supply for valves in ABS hydraulic unit -N55- to ABS control module (w/EDL) -J104-		Perform test step 2
Voltage supply (terminal X) on ABS control module (w/EDL) -J104-		Perform test step 3
Function of brake light switch -F-		Perform test step 4
Resistance of right front ABS wheel speed sensor -G45-		Perform test step 5
Resistance of left front ABS wheel speed sensor -G47-		Perform test step 6
Resistance of right rear ABS wheel speed sensor -G44-		Perform test step 7
Resistance of rear left ABS wheel speed sensor -G46-		Perform test step 8
Voltage signal of right front ABS wheel speed sensor -G45-		Perform test step 9
Voltage signal of left front ABS wheel speed sensor -G47-		Perform test step 10

To test component
Voltage signal of right rear ABS wheel speed sensor -G44-		Perform test step 11
Voltage signal of rear left ABS wheel speed sensor -G46-		Perform test step 12
Coding bridge		Perform test step 13
Voltage supply for V.A.G 1551, T16 connector		Perform test step 14
Resistance of K wire for On Board Diagnostic (OBD), T16 connector		Perform test step 15
Function of ABS warning light -K47-		Perform test step 16
Function of warning light for brake system -K118-		Perform test step 17
Function of ABS hydraulic pump -V64-		Perform test step 18
Check of data bus wiring		Perform test step 19
Activation of longitudinal acceleration sensor -G251-1)		Perform test step 20
Function of ESP Control lamp -K155-		Perform test step 21

1) All-wheel drive vehicles with Haldex coupling only.