Safety precautions: Notes
WARNING: This page is about a different variant/trim than selected.
Observe following if test and measuring instruments are required during a test drive:
- Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.
- When test and measuring instruments are operated from the front passenger seat there is a danger that the person sitting there could be injured in an accident when the airbag is triggered.
- Connect V.A.G 1551 Scan Tool and select address word 03 for "Brake electronics" with ignition switched on; Refer to V.A.G 1551 Scan Tool, connecting and selecting function
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press keys 0 and 8 to select function "Read measured value block".
Indicated on display
| Rapid data transfer Q 08 - Read measured value block |
- Confirm entry with key Q.
Indicated on display
| Read measured value block Enter display group number XXX |
- Enter display group number. Refer to List of selectable display group numbers, List of selectable display group numbers .