Automatic test sequence
WARNING: This page is about a different variant/trim than selected.
The automatic test sequence checks all the Diagnostic Trouble Code (DTC) memories of the control modules.
- Switch ignition on.
Indicated on display
| V.A.G - On Board Diagnostic HELP 1 - Rapid data transfer1) 2 - Blink code output1) |
1) Is displayed alternately
- Press key -1- for "Rapid data transfer" operating mode.
- Switch on printer with the Print key (indicator lamp in key lights up).
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press key -0- twice; 00 enters "Automatic test sequence" function.
- Confirm entry with Q key.
The V.A.G 1551 Scan Tool display will show the control module identification, e.g:
| 1J0 907 379 D ABS 20 IE CAN0001 → Coding 03604 WSC XXXXX |
Thereafter all control module identifications with eventual DTC memory entries are displayed