ABS control module, coding: Notes
WARNING: This page is about a different variant/trim than selected.
- All functions which could previously be performed with V.A.G 1551 can also be performed with the tester VAS 5051.
- Warning light for ABS -K47- and warning light for brake system -K118- flash when control module is coded with 00000. An entry is not set in the DTC memory.
- The ABS control module (w/EDL) -J104- must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.
Coding is only possible after the workshop code (WSC) has been entered into the V.A.G 1551 Scan Tool.