Electrical And Electronic Components And Their Locations: Notes
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
1 - Transmission Control Module (TCM) J217
- Location, refer to Location of Transmission Control Module (TCM) J217
- Removing, refer to Transmission Control Module (TCM) J217 Removing
- Installing, refer to Install Transmission Control Module (TCM) J217
- The control module transmits and receives data from the data bus.
- If control module has been replaced, basic setting must be initiated.
2 - Engine control module
- Location and removing and installing, refer to Engine control module
- The control module transmits and receives data from data bus.
- If control module has been replaced, basic setting must be initiated.
3 - Instrument cluster with Data Bus On Board Diagnostic Interface J533.
- Selector lever position display
4 - Data Link Connector (DLC)
- Location, refer to Data Link Connector (DLC)
5 - Multi-Function Transmission Range (TR) Switch F125
- Removing, installing and adjusting. Refer to Multi-Function Transmission Range (TR) Switch F125 , removing, installing and adjusting .
- Can be checked using "Guided Fault Finding" of VAS 5051.
6 - Intermediate Shaft Speed Sensor G265
- Picks up a signal at gear A (intermediate speed).
- Location: in transmission.
- Can be checked using "Guided Fault Finding" of VAS 5051.
- Removing and installing, refer to Vehicle Speed Sensor (VSS) G68 and Intermediate Shaft Speed Sensor G265 , removing and installing
7 - Vehicle Speed Sensor (VSS) G68
- Measures transmission output shaft speed (vehicle speed).
- Location: in transmission.
- Can be checked using "Guided Fault Finding" of VAS 5051.
- Removing and installing, refer to Vehicle Speed Sensor (VSS) G68 and Intermediate Shaft Speed Sensor G265 , removing and installing
8 - Transmission Input Speed (RPM) Sensor G182
- Measures transmission input shaft speed (turbine shaft).
- Location: in transmission.
- Can be checked using "Guided Fault Finding" of VAS 5051.
- Removing and installing, refer to Transmission Input Speed (RPM) Sensor G182 , removing and installing.
9 - Valve body
- Location: in transmission.
- Removing and installing, refer to Valve body .
- The solenoid valves N88 , N89 , N90 , N91 , N92 , N93 , N281 , N282 and N283 are attached to the valve body.
- The valves can be checked using "Guided Fault Finding" in VAS 5051.
10 - Transmission Fluid Temperature Sensor G93
- Location: in transmission.
- Can be checked using "Guided Fault Finding" in VAS 5051.
- As part, available only with transmission wiring harness Electronic Parts Catalog "ETKA".
- Removing and installing. Refer to Transmission Fluid Temperature Sensor G93 with wiring harness, removing and installing
11 - Shift Lock Solenoid N110
- Location and removing and installing. Refer to Shift Lock Solenoid N110 , removing and installing .
- Can be checked using "Guided Fault Finding" in VAS 5051.
12 - Brake Pressure Switch F270
- Location: switch is located on front wall, in brake line to right front brake calliper.
- Signal can be checked using "Guided Fault Finding" in VAS 5051.
13 - Brake Light Switch F
- Location and removing and installing. Refer to Brake Light Switch F
- Can be checked using "Guided Fault Finding" in VAS 5051.
14 - Park/Neutral Position (PNP) Relay J226
- Location, refer to Park/Neutral Position (PNP) Relay J226