Diagnostic Mode 09: Vehicle information

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For all calibration and immobilizer information. Refer to the EBAHN-Website.

Diagnostic Mode 09 is used to display vehicle specific information, e.g. the different Engine Control Module (ECM) versions.

NOTE:

Depending on scan tool and protocol used, diagnostic mode 09 and the information provided may be referred to by a different name.

Test requirement

No DTCs stored in the DTC memory.

Procedure

Connect the scan tool.
Switch the ignition on.
Select "Mode 09: Vehicle information".
Select the desired "Test-ID".

The information requested will be displayed on the scan tool screen.

The following table is a numerical list of all "Test-IDs" that may be selected.

Test-ID	Diagnostic text
02:	Vehicle identification number e.g.
	A different 17 digit number will be displayed for each vehicle
04:	Calibration identification e.g.
	Engine Control Module (ECM)
	Transmission Control Module (TCM)
06:	CVN (check sum) e.g.
	EC5AE460 the check sum is different for every control module version
	000D105

Switch the ignition off.
End of diagnosis.