Combi-valve, checking
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Hand vacuum pump V.A.G 1390
Test conditions
- There must be no malfunctions stored in DTC memory
- Output diagnostic test performed
- Vacuum lines and hose connections free of leaks
- Vacuum lines not blocked or kinked
Test sequence
- Remove vacuum hose - 1 - on Secondary Air Injection (AIR) Solenoid Valve N112 - 2 -.
- Connect Hand Vacuum Pump V.A.G 1390 to vacuum hose - 1 -.
NOTE:
- Do not use compressed air during following check!
- Disconnect pressure hose - 3 - at Secondary Air Injection (AIR) pump motor V101 and blow air in with light pressure - arrow -. Combination valve must be closed.
NOTE:
- To disengage, compress the buttons at the hose coupling.
- Operate Hand vacuum pump V.A.G 1390. Valve must open.
If combi-valve does not open:
- Replace combination valve.